Dell Latitude CPi Service Manual - Page 58

lel port connector. Also, check that the microphone boot is properly located

Get Dell Latitude CPi PDF manuals and user guides View all Dell Latitude CPi manuals
Add to My Manuals
Save this manual to your list of manuals

Page 58 highlights

NOTE: Support the display assembly with a book or similar object so that the display assembly does not open beyond 180 degrees. The palmrest assembly is secured in the bottom case assembly by four snaps and tabs on the right and left ends of the palmrest. Take care not to damage the snaps when removing the palmrest. NOTE: When replacing the palmrest, ensure that the vertical tab at the back of the palmrest fits on the outside of the system board assembly, near the parallel port connector. Also, check that the microphone boot is properly located in its slot on the top EMI shield and is fitted within the palmrest assembly. 4-22 Dell Latitude CP and CPi Service Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
4-22
Dell Latitude CP and CPi Service Manual
NOTE: Support the display assembly with a book or similar object so that
the display assembly does not open beyond 180 degrees.
The palmrest assembly is secured in the bottom case assembly by four
snaps and tabs on the right and left ends of the palmrest. Take care not to
damage the snaps when removing the palmrest.
NOTE: When replacing the palmrest, ensure that the vertical tab at the back of
the palmrest fits on the
outside
of the system board assembly, near the paral-
lel port connector. Also, check that the microphone boot is properly located in
its slot on the top EMI shield and is fitted within the palmrest assembly.