Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 1100

Supported releases 10.4.3.0 or later max-backoff Configures a time interval, in milliseconds (ms). This is the duration the switch waits between the connection attempts to the controller. Syntax Parameters Default Command Mode Usage Information Example max-backoff interval interval-Enter the amount of time, in ms. This is the duration the switch waits between the connection attempts to the controller, from 1000 to 180000 ms. 8000 ms CONFIGURATION-NVE-OVSDB The no version of this command replaces the default maximum wait time configuration in the switch. OS10(config)# nve OS10(config-nve)# controller ovsdb OS10(config-nve-ovsdb)# max-backoff 40000 Supported Releases 10.4.3.0 or later nve-controller Assigns the interfaces to be managed by the controller. Syntax Parameters Default Command mode Usage information nve-controller None None INTERFACE The interface must be in Switchport Trunk mode when adding the interface to the controller. If the interface is not in the Switchport Trunk mode, the system displays the following error message: % Error: Interface ethernet1/1/1, must be in switchport trunk for controller mode. Example NOTE: If the interface has active port-scoped VLAN (Port,VLAN) pairs configured by the controller, you cannot remove an interface from the controller. The no version of this command removes the interface from the controller and removes any VXLAN binding associated with the interface. OS10(config)# interface ethernet 1/1/1 OS10(config-if-eth1/1/1)# nve-controller Supported releases 10.4.3.0 or later nve controller ssl-key-generate Generates the SSL certificate for the OVSDB server to setup the SSL connection with the controller. Syntax nve controller ssl-key-generate 1100 VXLAN