Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 1375

random-detect weight Configures the exponential weight value used to calculate the average queue depth for the WRED profile. Syntax Parameters Default Command Mode Usage Information Example random-detect weight weight-value weight-value - Enter a value for the weight, from 1 to 15. Not configured WRED CONFIGURATION The no version of this command removes the weight factor from the WRED profile. OS10(config)# wred test_wred OS10(config-wred)# random-detect weight 10 Supported Releases 10.4.0E(R1) or later service-policy Configures the input and output service policies. Syntax Parameters Default Command Mode Usage Information service-policy {input | output} [type {qos | queuing | network-qos}] policy-map-name ● input-Enter to assign a QoS policy to the interface input. ● output-Enter to assign a QoS policy to the interface output. ● qos-Enter to assign a qos type policy-map. ● queuing-Enter to assign the queuing type policy-map. ● network-qos-Enter to assign the network-qos type policy-map. ● policy-map-name-Enter the policy-map name up to a maximum of 32 characters. Not configured INTERFACE Attach only one policy-map to the interface input and output for each qos and queuing policy-map type. You can attach four service-policies to the system QoS-one each for qos, queueing, and network-qos type policy-maps. When you configure interface-level policies and system-level policies, the interface-level policy takes precedence over the system-level policy. NOTE: Apply the service-policy input type network-qos command only on the applicable interfaces instead of the SYSTEM-QoS mode. Applying this command in the global SYSTEM-QoS mode might cause CRC errors on the remote end fiber channel devices. You can apply this command on all downstream and upstream interfaces using the interface range ethernet command. Example OS10(conf-if-eth1/1/7)# service-policy input type qos p1 Supported Releases 10.2.0E or later set cos Sets a cost of service (CoS) value to mark L2 802.1p (dot1p) packets. Syntax set cos cos-value Quality of service 1375