Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 188

Supported Releases 10.5.1.0 or later ptp clock Configures the PTP clock type on the switch and specifies the profile for the clock. Syntax Parameters ptp clock {boundary | end-to-end-transparent} [profile {g8275.1 | systemdefault}] ● boundary-Enables boundary clock. ● end-to-end-transparent-Enables end-to-end transparent clock. ● g8275.1-Configures the clock to adhere to the ITU G.8275.1 profile. ● system-default-Configures the clock to adhere to the system default profile. Defaults Command Mode Security and Access Usage Information System default profile, when PTP clock is configured. CONFIGURATION Netadmin and sysadmin Enables the PTP clock and configures the clock type and profile on the switch. The clock identity is an array of 8 bytes. The system determines the clock identity from the system MAC address. The most significant 3 bytes (OUI portion) of the MAC address is assigned to the most significant 3 bytes of clock identity. The least significant 3 bytes of the MAC address is assigned to the least significant 3 bytes of the clock identity. Fourth and fifth bytes of clock identity can take on the one of the following values: 0xFF or 0xFE. The G8275.1 profile is applicable only for boundary clock. When you configure an attribute, the new configuration overrides the attribute configuration that is defined in the profile. The no form of this command removes the configuration. Example OS10(config)# ptp clock boundary OS10(config)# ptp clock boundary profile g8275.1 Supported Releases 10.5.1.0 or later ptp delay-mechanism Configures the delay mechanism of the PTP boundary clock. Syntax Parameters Defaults Command Mode Security and Access Usage Information Example ptp delay-mechanism {end-to-end} end-to-end-Enables delay request-response mechanism for the boundary clock. End-to-end INTERFACE CONFIGURATION Netadmin and sysadmin This configuration is only applicable for the boundary clock. The no form of this command removes the configuration. OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ptp delay-mechanism end-to-end Supported Releases 10.5.1.0 or later 188 System management