Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 187

Example Supported Releases OS10# debug ptp servo level 2 10.5.1.0 or later master Configures master clocks for the PTP slave devices. Syntax Parameters Defaults Command Mode Security and Access Usage Information master ip-address ip-address-Specifies the IP addresses of the master clock devices. None for IP address; unicast negotiation disabled INTERFACE CONFIGURATION - SLAVE submode Netadmin and sysadmin You can configure a maximum of eight master clock devices. The system reports an error when you configure more than eight master clock devices. The no form of this command removes the configuration. Example OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ptp transport ipv4 unicast slave OS10(conf-ethernet1/1/1-ptp-ipv4-slave)# master 10.10.10.1 OS10(conf-ethernet1/1/1-ptp-ipv4-slave)# master 10.10.10.2 Supported Releases 10.5.1.0 or later ptp announce Configures the interval between successive announce messages and the timeout for the message. Syntax Parameters ptp announce {[interval log2-seconds] | [timeout multiplier]} ● log2-seconds-Configures the logarithmic time interval in seconds between successive announce messages. For the system default profile, enter a value from -2 to 4 (1/4 s to 16 s). For the ITU G.8275.1 profile, enter a value from -3 to 4 (1/8 s to 16 s). ● multiplier-Configures the count of announce message intervals that have to pass without receipt of an announce message to declare a timeout. Enter a value from 2 to 10. Defaults ● Interval: ○ System default profile: 1 ○ ITU G.8275.1 profile: -3 ● Timeout: 3 Command Mode Security and Access Usage Information Example INTERFACE CONFIGURATION Netadmin and sysadmin When a timeout event occurs, the system selects a port with dynamic role to be the master. The no form of this command removes the configuration. OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ptp announce interval 1 OS10(conf-if-eth1/1/1)# ptp announce timeout 5 System management 187