Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 822

Default Command Mode Usage Information Example ● centisecs centisecs - (Optional) Enter a value in multiples of 25, from 25 to 4075. 1 second or 100 centisecs INTERFACE-VRRP Dell EMC recommends keeping the default setting for this command. If you change the time interval between VRRP advertisements on one router, change it on all routers. The no version of this command sets the VRRP advertisements timer interval back to its default value, 1 second or 100 centisecs. OS10(conf-eth1/1/6-vrid-250)# advertise-interval 120 centisecs 100 Supported Releases 10.2.0E or later authentication-type Enables authentication of VRRP data exchanges. Syntax Parameters authentication-type simple-text password simple-text password - Enter a simple text password. Default Command Mode Usage Information Example Disabled INTERFACE-VRRP With authentication enabled, OS10 ensures that only trusted routers participate in routing in an autonomous network. The no version of this command disables authentication of VRRP data exchanges. OS10(conf-ethernet1/1/6-vrid-250)# authentication simple-text eureka Supported Releases 10.2.0E or later preempt Permits or preempts a backup router with a higher priority value to become the master router. Syntax Parameters Default Command Mode Usage Information Example preempt None Enabled INTERFACE-VRRP VRRP uses preempt to determine what happens after a VRRP backup router becomes the master. With preempt enabled by default, VRRP switches to a backup if that backup router comes online with a priority higher than the new master router. If you disable preempt, VRRP switches only if the master fails. The no version of this command disables preemption. OS10(conf-eth1/1/5-vrid-254)# preempt Supported Releases 10.2.0E or later priority Assigns a VRRP priority value for the VRRP group. The VRRP uses this value during the master election process. Syntax priority number 822 Layer 3