Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 793

Supported Releases Neighbor Count is 1, Adjacent neighbor count is 1 Adjacent with neighbor 2.2.2.2(Designated Router) 10.3.0E or later show ipv6 ospf neighbor Displays a list of OSPFv3 neighbors connected to the local router. Syntax Parameters show ipv6 ospf [vrf vrf-name] neighbor ● vrf vrf-name - Enter the keyword vrf followed by the name of the VRF to display a list of OSPFv3 neighbors in that VRF. Default Command Mode Usage Information Not configured EXEC ● Neighbor ID-Displays the neighbor router ID. ● Pri-Displays the priority assigned neighbor. ● State-Displays the OSPF state of the neighbor. ● Dead Time-Displays the expected time until the system declares the neighbor dead. ● Interface ID-Displays the neighbor interface ID ● Interface-Displays the interface type, node/slot/port or number information. Example OS10(conf-if-eth1/1/1)# show ipv6 ospf neighbor Neighbor ID Pri State Dead Time Interface ID Interface 2.2.2.2 1 Full/DR 00:00:30 5 ethernet1/1/1 Supported Releases 10.3.0E or later show ipv6 ospf statistics Displays OSPFv3 traffic statistics. Syntax Parameters show ipv6 ospf [instance-number] statistics [interface interface] ● instance-number - (Optional) Enter an OSPFv3 instance number, from 1 to 65535. ● interface interface - (Optional) Enter the interface information: ○ ethernet node/slot/port[:subport] - Enter an Ethernet port interface. ○ port-channel number - Enter the port-channel interface number, from 1 to 128. ○ vlan vlan-id - Enter the VLAN ID number, from 1 to 4093. Default Command Mode Usage Information Example Not configured EXEC This command displays OSPFv3 traffic statistics for a specified instance or interface, or for all OSPFv3 instances and interfaces. OS10# show ipv6 ospf interface ethernet 1/1/1 Interface ethernet1/1/1 Receive Statistics rx-invalid 0 rx-invalid-bytes 0 rx-hello 0 rx-hello-bytes 0 rx-db-des 0 rx-db-des-bytes 0 rx-ls-req 0 rx-ls-req-bytes 0 rx-ls-upd 0 rx-ls-upd-bytes 0 Layer 3 793