Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 487

Supported Releases 10.2.0E or later clear lldp table Clears LLDP neighbor information for all interfaces. Syntax Parameters Default Command Mode Usage Information Example clear lldp table None Not configured EXEC Neighbor information clears on all interfaces. OS10# clear lldp table Supported Releases 10.2.0E or later lldp enable Enables or disables LLDP globally. Syntax Parameters Default Command Mode Usage Information Example lldp enable None Enabled CONFIGURATION This command enables LLDP globally for all Ethernet PHY interfaces, except on those interfaces where you manually disable LLDP. The no version of this command disables LLDP globally irrespective of whether you manually disable LLDP on an interface. OS10(config)# lldp enable Supported Releases 10.3.1E or later lldp holdtime-multiplier Configures the multiplier value for the hold time. Syntax Parameters Default Command Mode Usage Information Example lldp holdtime-multiplier integer integer - Enter the holdtime-multiplier value, from 2 to 10. 4 CONFIGURATION Hold time is the amount of time in seconds that a receiving system waits to hold the information before discarding it. Formula: Hold Time = (Updated Frequency Interval) x (Hold Time Multiplier). The no version of this command resets the value to the default. OS10(config)# lldp holdtime-multiplier 2 Supported Releases 10.2.0E or later Layer 2 487