Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 754

ip ospf dead-interval Sets the time interval since the last hello-packet was received from a router. After the interval elapses, the neighboring routers declare the router dead. Syntax Parameters Default Command Mode Usage Information Example ip ospf dead-interval seconds seconds - Enter the dead interval value in seconds, from 1 to 65535. 40 seconds INTERFACE The dead interval is four times the default hello-interval by default. The no version of this command resets the value to the default. OS10(conf-if-vl-10)# ip ospf dead-interval 10 Supported Releases 10.2.0E or later ip ospf hello-interval Sets the time interval between the hello packets sent on the interface. Syntax Parameters Default Command Mode Usage Information ip ospf hello-interval seconds seconds - Enter the hello-interval value in seconds, from 1 to 65535. 10 seconds INTERFACE All routers in a network must have the same hello time interval between the hello packets. The no version of the this command resets the value to the default. NOTE: When you configure hello-interval for OSPF, the OSPF dead-interval value is implicitly set to a value four times greater than the hello-interval value. Example OS10(conf-if-vl-10)# ip ospf hello-interval 30 Supported Releases 10.2.0E or later ip ospf message-digest-key Enables OSPF MD5 authentication and sends an OSPF message digest key on the interface. Syntax Parameters ip ospf message-digest-key keyid md5 key ● keyid - Enter an MD5 key ID for the interface, from 1 to 255. ● key - Enter a character string as the password. A maximum of 16 characters. Defaults Command Mode Usage Information Example Not configured INTERFACE All neighboring routers in the same network must use the same key value to exchange OSPF information. The no version of this command deletes the authentication key. OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ip ospf message-digest-key 2 md5 sample12345 Supported Releases 10.3.0E or later 754 Layer 3