Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 794

Supported Releases rx-ls-ack 0 rx-ls-ack-bytes 0 Transmit Statistics tx-hello 1054 tx-hello-bytes 37944 tx-db-des 0 tx-db-des-bytes 0 tx-ls-req 0 tx-ls-req-bytes 0 tx-ls-upd 0 tx-ls-upd-bytes 0 tx-ls-ack 0 tx-ls-ack-bytes 0 Error packets (Receive statistics) bad-src 0 dupe-id 0 hello-err 0 mtu-mismatch 0 nbr-ignored 0 resource-err 0 bad-lsa-len 0 lsa-bad-type 0 lsa-bad-len 0 lsa-bad-cksum 0 hello-tmr-mismatch 0 dead-ivl-mismatch 0 options-mismatch 0 nbr-admin-down 0 own-hello-drop 0 self-orig 0 wrong-length 0 version-mismatch 0 area-mismatch 0 10.4.0E(R1) or later timers spf (OSPFv3) Enables shortest path first (SPF) throttling to delay an SPF calculation when a topology change occurs. Syntax Parameters timers spf [start-time [hold-time [max-wait]]] ● start-time - Sets the initial SPF delay in milliseconds, from 1 to 600000; default 1000. ● hold-time - Sets the additional hold time between two SPF calculations in milliseconds, from 1 to 600000; default 10000. ● max-wait - Sets the maximum wait time between two SPF calculations in milliseconds, from 1 to 600000; default 10000. Default ● start-time - 1000 milliseconds ● hold-time - 10000 milliseconds ● max-wait - 10000 milliseconds Command Mode Usage Information ROUTER-OSPFv3 OSPFv2 and OSPFv3 support SPF throttling. By default, SPF timers are disabled in an OSPF instance. Use SPF throttling to delay SPF calculations during periods of network instability. In an OSPF network, a topology change event triggers an SPF calculation after a specified start time. When the start timer finishes, a hold time may delay the next SPF calculation for an additional time. When the hold timer is running: ● Each time a topology change occurs, the SPF calculation delays for double the configured hold time up to maximum wait time. ● If no topology change occur, an SPF calculation performs and the hold timer resets to its configured value. If you do not specify a start-time, hold-time, or max-wait value, the default values are used. The no version of this command removes the configured SPF timers and disables SPF throttling in an OSPF instance. Example OS10(config)# router ospfv3 100 OS10(config-router-ospfv3-100)# timers spf 1345 2324 9234 OS10(config-router-ospfv3-100)# do show ipv6 ospf Routing Process ospfv3 100 with ID 129.240.244.107 SPF schedule delay 1345 msecs, Hold time between two SPFs 2324 msecs Min LSA origination 5000 msec, Min LSA arrival 1000 msec Min LSA hold time 0 msec, Max LSA wait time 0 msec Number of area in this router is 1, normal 1 stub 0 nssa Area (0.0.0.1) Number of interface in this area is 1 SPF algorithm executed 2 times 794 Layer 3