Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 699

template Creates a peer-group template to assign it to BGP neighbors. Syntax Parameters Default Command Mode Usage Information template template-name template-name - Enter a peer-group template name. A maximum of 16 characters. Not configured CONFIG-ROUTER-BGP Members of a peer-group template inherit the configuration properties of the template and share the same update policy. The no version of this command deletes a peer-template configuration. NOTE: To configure these settings for a nondefault VRF instance, you must first enter the ROUTERCONFIG-VRF sub mode using the following commands: 1. Enter the ROUTER BGP mode using the router bgp as-number command. 2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. Example OS10(conf-router-bgp-10)# template solar OS10(conf-router-bgp-template)# Supported Releases 10.3.0E or later timers Adjusts BGP keepalive and holdtime timers. Syntax Parameters timers keepalive holdtime ● keepalive-Enter the time interval, in seconds, between keepalive messages sent to the neighbor routers, from 1 to 65535. ● holdtime-Enter the time interval, in seconds, between the last keepalive message and declaring a router dead, from 3 to 65535. Default Command Mode Usage Information Example keepalive 60 seconds; holdtime 180 seconds ROUTER-BGP The configured timer value becomes effective after a BGP hard reset. The timer values negotiate from peers. The no version of this command resets the value to the default. OS10(conf-router-bgp)# timers 30 90 Supported Releases 10.3.0E or later update-source Enables using Loopback interfaces for TCP connections to stabilize BGP sessions. Syntax update-source loopback interface-id Parameters loopback interface-id - Specify a Loopback interface ID, from 0 to 16383. Defaults None Command Modes ● CONFIG-ROUTER-NEIGHBOR ● CONFIG-ROUTER-TEMPLATE Layer 3 699