Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 186

TR2(conf-if-eth1/1/1:1)# ptp transport ipv4 multicast TR2(config)# interface ethernet 1/1/25:1 TR2(conf-if-eth1/1/25:1)# ptp enable TR2(conf-if-eth1/1/25:1)# ptp transport ipv4 multicast PTP commands clear ptp counters Resets the statistics of the PTP packets that are received at or transmitted from an interface. Syntax Parameters clear ptp counters [{ethernet node/slot/port[:subport]} | {port-channel port-channel-id}] ● ethernet node/slot/port[:subport]-Enter the Ethernet interface information. ● port-channel port-channel-id-Enter the port channel interface number. Defaults Command Mode Security and Access Usage Information Example None EXEC Netadmin and sysadmin None OS10# clear ptp counters ethernet 1/1/14 Supported Releases 10.5.1.0 or later debug ptp Enables debug logs for the PTP stack. Syntax Parameters debug ptp {all | bmca | protocol | servo | system | timestamps} {level level} ● all-All debug logs of system, stack, and servo ● bmca-Best Master Clock Algorithm (BMCA) logs ● protocol-PTP protocol engine and transport layer logs ● servo-Servo and PLL logs ● system-System and task logs ● timestamps-Logs related to timestamps ● level-Specify the debug log level. Enter a value from 1 to 5. Level 1 is critical and level 5 is informational. Defaults ● Debug: Not enabled ● Debug level: 1 Command Mode Security and Access Usage Information EXEC Netadmin and sysadmin Debug log messages are stored in the following file: /var/log/ptp.log. The debug ptp system command logs all information about internal data structures and is useful for debugging issues. 186 System management