Dell OptiPlex 3011 AIO Owner's Manual - Page 17
Installing the Memory, Removing the System Board Cover
View all Dell OptiPlex 3011 AIO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installing the Memory 1. Align the notch on the memory-card with the tab in the system-board connector. 2. Press down on the memory module until the release tabs spring back to secure them in place. 3. Place the memory cover back into its place and tighten the screw to secure it. 4. Install: a) back cover b) VESA stand c) stand cover 5. Follow the procedures in After Working Inside Your Computer. Removing the System Board Cover 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove: a) stand cover b) VESA stand c) back cover 3. Remove the screw that secures the system board cover to the computer. 4. Lift the system board cover up to remove it from the computer. 17
Installing the Memory
1.
Align the notch on the memory-card with the tab in the system-board connector.
2.
Press down on the memory module until the release tabs spring back to secure them in place.
3.
Place the memory cover back into its place and tighten the screw to secure it.
4.
Install:
a)
back cover
b)
VESA stand
c)
stand cover
5.
Follow the procedures in
After Working Inside Your Computer
.
Removing the System Board Cover
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove:
a)
stand cover
b)
VESA stand
c)
back cover
3.
Remove the screw that secures the system board cover to the computer.
4.
Lift the system board cover up to remove it from the computer.
17