Dell OptiPlex GXi Reference and Installation Guide ( - Page 58
Unpacking Your Hardware Option, Removing the Computer Cover
View all Dell OptiPlex GXi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Unpacking Your Hardware Option When you remove an option from its shipping carton, you may find it wrapped in antistatic packing material designed to protect it from electrostatic damage. Do not remove the packing material until you are ready to install the option. CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions at the front of this guide. 3. Remove the cover. Facing the left side cover, press the release button (located at the bottom-left corner of the front bezel) and lift the bottom of the cover, allowing it to pivot up toward you (see Figure 5-2). Disengage the tabs that secure the cover to the top of the chassis, and lift the cover away. Removing the Computer Cover Use the following procedure to remove the computer cover: 1. Turn off your computer and peripherals, and observe the Warning for Your Personal Safety and Protection of Your Equipment described earlier in this chapter. Also observe the safety instructions at the front of this guide. 2. If you have installed a padlock through the padlock ring on the back panel (see Figure 5-1), remove the padlock. Figure 5-1. Padlock Installed release button Figure 5-2. Removing the Computer Cover Replacing the Computer Cover Use the following procedure to replace the computer cover: 1. Check all cable connections, especially those that might have come loose during your work. Fold cables out of the way so that they do not catch on the computer cover. Make sure cables are not routed over the drive cage-they will prevent the cover from closing properly. 2. Check to see that no tools or extra parts (including screws) are left inside the computer's chassis. 5-2 Dell OptiPlex GXi Mini Tower Systems Reference and Installation Guide