Dell PowerConnect 6024 User's Guide (.htm) - Page 45

Accessing the Switch Through the CLI The switch can be managed over a direct connection to the console port or via a Telnet connection. For information about out-of-band management ports, see "Out-of-Band Management Port." Using the CLI is similar to entering commands on a Linux system. If access is via a Telnet connection, ensure the device has an IP address defined and that the workstation used to access the device is connected to the device prior to beginning using CLI commands. For information about configuring an initial IP Address, see "Initial Configuration." NOTE: Ensure the client is loaded, before using the CLI. Console Connection 1 Power on the switch and wait until the startup is complete. 2 When the Console> prompt displays, type enable and press . 3 Configure the device and enter the necessary commands to complete the required tasks. 4 When finished, exit the session with the quit or exit command. NOTE: If a different user logs into the system in the Privilege EXEC command mode, the current user is logged off and the new user is logged in. Telnet Connection Telnet is a terminal emulation TCP/IP protocol. ASCII terminals can be virtually connected to the local device through a TCP/IP protocol network. Telnet is an alternative to a local login terminal where a remote login is required. Your switch supports up to four simultaneous Telnet sessions. All CLI commands can be used over a telnet session. To start a Telnet session: 1 Select Start > Run. 2 In the Run window, type Telnet in the Open field. 3 Click OK to begin the Telnet session. Using Dell OpenManage Switch Administrator 55