Dell PowerConnect 6024 User's Guide (.htm) - Page 451

Table 10-15. Policy CLI Commands CLI Command Description class class-map-name Defines the traffic classification, and [access-group acl-name] enters policy map class configuration mode. trust [cos | dscp | tcp-udp-port] Configures the trust state, which selects the value that QoS uses as the source of internal DSCP value. set {dscp new-dscp | queue queue-id | cos new-cos} Sets new values in the IP packet. Note: This command is mutually exclusive of the trust command. police committed-ratebps committed-burstbyte [exceed-action {drop | policed-dscptransmit}] Defines a single policer for classified traffic. qos aggregate-policer aggregate-policer-name committed-rate-bps excess-burst-byte exceed-action {drop | policed-dscp-transmit} Defines the police parameters that can be applied to multiple traffic classes within the same policy map. The following is an example of the CLI commands: console(config)# policy map policy1 console(config-pmap)# class class1 access-group dell console(config-pmap)# trust cos console(config-pmap)# set dscp 56 console(config-pmap)# police 124000 96000 exceed-action drop console(config-pmap)# exit console(config)# qos aggregate-policer policer1 124000 96000 exceed-action drop Applying Policies to Interfaces Use the QoS Policy Binding page to implement policies on interfaces. To open the page, click Quality of Service→Advanced QoS Mode→Policy Binding in the tree view. Configuring Quality of Service 461