Dell PowerConnect 6024 User's Guide (.htm) - Page 57

The system will prompt you with a default answer; by pressing enter, you accept the default. After you configure basic settings using the Setup Wizard, you can manage the device from the Out-of-band management port. Would you like to enter the setup wizard? [Y/N] Y 1 If [N] is entered, the Setup Wizard is exited. If there is no response within 60 seconds, the Setup Wizard is automatically exited and the CLI console prompt is displayed. If [Y] is entered, the Setup Wizard provides interactive guidance through the initial device configuration. NOTE: If there is no response within 60 seconds, and there is a BootP server on the network, an address is retrieved from the BootP server. NOTE: The user can exit the Setup Wizard at any time by entering [ctrl+z]. Wizard Step 1 If [Y] is entered the following is displayed: The system is not setup for SNMP management by default. To manage the switch using SNMP (required for Dell Network Manager) you can: • Setup the initial SNMP version 2 account now. • Return later and setup the SNMP version 2 account. (For more information on setting up a SNMP version 2 account, see the user documentation). Would you like to setup the SNMP management interface now? [Y/N] Y 2 Enter [N] to skip to Step 2 or enter [Y] to continue the Setup Wizard. If [Y] is entered the following is displayed: To setup the SNMP management account you must specify the management system IP address and the "community string" or password that the particular management system uses to access the switch. The wizard automatically assigns the highest access level [Privilege Level 15] to this account. You can use Dell Network Manager or other management interfaces to change this setting later, and to add additional management system later. For more information on adding management systems, see the user documentation. To add a management station: Please enter the SNMP community string to be used: Configuring the Switch 67