Dell PowerConnect W-Airwave W-Airwave 7.2 Configuration Guide - Page 110
AP Load Balancing Util, RSSI Falloff Wait Time
View all Dell PowerConnect W-Airwave manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Table 47 Profiles > RF > Optimization Profile Settings (Continued) Field Default Description AP Load Balancing Util 0 Wait Time (0-360,000 sec) Station Handoff Assist No Detect Association No Failure Coverage Hole No Detection Hole Good RSSI 20 Threshold (0-65,535) Hole Good Station 30 Ageout (sec) Hole Detection 180 Interval (sec) Hole Idle Station 90 Timeout (sec) Hole Poor RSSI 10 Threshold (0-65,535) Detect Interference No Interference 100 Threshold (0-100%) Interference 60 Threshold Exceed Time (0-360000 sec) Interference Baseline 600 Time (0-360000 sec) RSSI Falloff Wait Time 0 (0-8 sec) Low RSSI Threshold 0 (0-255) RSSI Check Frequency 0 (0-255) Set the wait time for the AP when AP load balancing is enabled. When load balancing thresholds are exceeded, this setting defines the length of time before AP load balancing restarts on the AP. The supported range is 0 to 360,000 seconds, and defining a value of 0 disables this function. Enable or disable the ability of APs to hand users over to another adjacent AP, as available, in order to optimize or improve general network load. Enable or disable an AP's ability to detect failures in wireless user associations. Enable or disable an AP's ability to detect areas where an otherwise good RF signal is not reaching wireless clients to an adequate level. NOTE: This setting requires a Wireless Intrusion Protection license. Set the amount of time in seconds during which Received Signal Strength Indication (RSSI) is to check coverage holes. NOTE: This setting requires a Wireless Intrusion Protection license. Set the amount of time in seconds that an AP is unseen by any probes before it is deleted from the database. Enter 0 to disable ageout. NOTE: This setting requires a Wireless Intrusion Protection license. Sets the amount of time in seconds in which automatic hole detection should check for coverage holes. Enter 0 to disable this function. NOTE: This setting requires a Wireless Intrusion Protection license. Sets the amount of time in seconds before which an idle AP is deleted from the database, once it has become idle. Enter 0 to disable this function. NOTE: This setting requires a Wireless Intrusion Protection license. Sets the threshold at which RSSI deems coverage to be poor. Enables or disables interference detection for the APs to be configured with this optimization profile. Sets the maximum allowable interference to be tolerated by APs that are configured with this optimization profile, as a percentage. Sets the amount of time in seconds during which interference is allowed to exceed the threshold percentage. When interference exceeds the threshold percentage longer than the amount of time specified in this field, the threshold has been exceeded. Sets the period of time in seconds during which interference levels are to be monitored. This setting governs the deployment of the interference percentage threshold and the threshold exceed time. Sets the maximum time to wait with decreasing received signal strength indication (RSSI) before de-authorization is sent to the client. Sets the low threshold for received signal strength indication (RSSI). If the RSSI for a specific client falls below this threshold and continues to fall for the RSSI Falloff Wait Time, then the AP sends a de-authorization command to the client. Such de-authorization removes the client from the current AP and forces it to re-authentication on a nearby AP. Sets the amount of time in seconds between RSSI coverage checks. 110 | Dell PowerConnect W Configuration Reference Dell PowerConnect W AirWave 7.2 | Configuration Guide