Dell PowerConnect W-Airwave W-Airwave 7.2 Configuration Guide - Page 14

For additional information, refer to the following sections in this document:  "Setting Up Initial Dell PowerConnect W Configuration" on page 21  "General Dell PowerConnect W AP Groups Procedures and Guidelines" on page 27 AP Overrides Section The second major component of Dell PowerConnect W Configuration is the AP Overrides page, appearing immediately below Dell PowerConnect W AP Groups in the Navigation Pane. Figure 6 illustrates this location and access: Figure 6 Dell PowerConnect W Configuration > AP Overrides Navigation AP Overrides operate as follows in Dell PowerConnect W Configuration:  Custom-created AP Overrides appear in the Dell PowerConnect W Configuration navigation pane, as illustrated in Figure 6.  Dell PowerConnect W controllers and AP devices operate in Dell PowerConnect W AP Groups that define shared parameters for all devices in those groups. The Dell PowerConnect W Configuration > Dell PowerConnect W AP Groups page displays all current Dell PowerConnect W AP groups.  AP Override allows you to change some parameters for any specific device without having to create an Dell PowerConnect W AP group per AP.  The name of any AP Override should be the same as the name of the device to which it applies. This establishes the basis of all linking to that device.  Once you have created an AP Override for a device in a group, you specify the WLANs to be included and excluded.  For additional information about how to configure and use AP Overrides, refer to these topics:  "AP Overrides Guidelines" on page 30  "AP Overrides" on page 42 in the Appendix 14 | Dell PowerConnect W Configuration in AWMS Dell PowerConnect W AirWave 7.2 | Configuration Guide