Dell PowerConnect W-Airwave W-Airwave 7.2 Configuration Guide - Page 96
General Settings, Other Settings, Profiles > QoS > VoIP Call Admission Control Profile Settings
View all Dell PowerConnect W-Airwave manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Table 39 Profiles > QoS > VoIP Call Admission Control Profile Settings Field Default Description General Settings Folder Top Name Blank Other Settings VoIP Call Admission No Control VoIP Active Load No Balancing VoIP Vocera Call 20 Capacity (0-255) VoIP NOE Call Capacity 10 (0-255) VoIP SIP Call Capacity (0- 10 255) VoIP SVP Call Capacity 10 (0-255) VoIP SCCP Call Capacity 10 (0-255) VoIP H.323 Call Capacity 10 (0-255) VoIP T-Spec Call 10 Capacity (0-255) VoIP Call Handoff 20 Reservation (0-100%) VoIP High-capacity 20 Threshold (0-100%) VoIP Send SIP 100 Trying No Set the folder with which the profile is associated. The drop-down menu displays all folders available for association with the profile. Enter the name of the threshold profile. Enable or disable VoIP Call Admission Control in this profile. Enable or disable load balancing in this profile. Specify the bandwidth allocation to Vocera voice calls when Admission Control is enabled. Specify the bandwidth allocation to New Office Environment (NOE) voice calls when Admission Control is enabled. Specify the bandwidth allocation to Session Initiated Protocol (SIP) voice calls when Admission Control is enabled. Specify the bandwidth allocation to SpectraLink Voice Priority (SVP) voice calls when Admission Control is enabled. Specify the bandwidth allocation to Cisco Skinny Client Control Protocol (SCCP) voice calls when Admission Control is enabled. Specify the bandwidth allocation to H323 protocol traffic when Admission Control is enabled. A WMM client can send a Traffic Specification (TSPEC) signaling request to the AP before sending traffic of a specific AC type, such as voice. You can configure the controller so that the TSPEC signaling request from a client is ignored if the underlying voice call is not active; this feature is disabled by default. If you enable this feature, you can also configure the number of seconds that a client must wait to start the call after sending the TSPEC request (the default is one second). You enable TSPEC signaling enforcement in the VoIP Call Admission Control profile. This field specifies the bandwidth allocation to T-Spec voice calls when Admission Control is enabled. Specify the total bandwidth to be reserved for call handoff. This field is a percentage of entire bandwidth. Specifies the threshold that defines high-capacity VoIP. This field is a percentage of entire bandwidth. The SIP invite call setup message is time-sensitive, as the originator retries the call as quickly as possible if it does not proceed. You can direct the controller to immediately reply to the call originator with a "SIP 100 - trying" message to indicate that the call is proceeding and to avoid a possible timeout. This is useful in conditions where the SIP invite may be redirected through a number of servers before reaching the controller. Enable or disable SIP call setup keepalive with this field. 96 | Dell PowerConnect W Configuration Reference Dell PowerConnect W AirWave 7.2 | Configuration Guide