Dell PowerConnect W-Airwave W-Airwave 7.2 Configuration Guide - Page 74

Table 24 Profiles > AP > System Profile Settings (Continued) Field Default Description SAP MTU (1024-1578 bytes) Bootstrap Threshold 8 (1-65535) Request Retry Interval 10 Maximum Request 10 Retries Keepalive Interval 60 (30-65535) Dump Server Telnet No SNMP Sys-contact RFprotect Server IP RFprotect Backup Server IP Configure Aeroscout No RTLS Server Ortonics Walljack Yes Ortonics LED Off Time- Yes Out Ortonics Low Temp 100 Ortonics High Temp 110 Configure RTLS Server No Remote-AP DHCP Server VLAN (1-4094) Specify the Service Access Point (SAP) maximum transmission unit (MTU) in bytes. The range is 1024 to 1578 bytes. Number of consecutive missed heartbeats on a GRE tunnel (heartbeats are sent once per second on each tunnel) before an AP rebootstraps. Adjust the bootstrap threshold to 30 if the network experiences packet loss. This makes the AP recover more slowly in the event of a failure, but it will be more tolerant to heartbeat packet loss. Dell PowerConnect W recommends the default maximum request retries and bootstrap threshold settings for most mesh networks; however, if you must keep your mesh network alive, you can modify the settings as described in this section. The modified settings are not applicable if mesh portals are directly connected to the controller. Enter in seconds the amount of time for retries. The supported range is from 1 to 65,535 seconds. Maximum number of times to retry AP-generated requests. The default is 10 times. If you must modify this setting, Dell PowerConnect W recommends a value of 10,000. The range is from 1 to 65,535. Define the keepalive interval in a range of 30 to 65,535 seconds. Enter the IP address for the dump server. Enables Telnet in this system profile. Enter an IP address to the value for SNMP sys_ contact, the SNMP system Sys location. Enter the IP address of the RFprotect server. Enter an IP address. When an Dell PowerConnect W controller is present in an Dell PowerConnect W RFprotect system, an Dell PowerConnect W AP that is acting as an RFprotect sensor can be configured and managed from the controller. As a Managed Sensor, the Dell PowerConnect W AP is managed by the controller but sends collected security data about the wireless environment to an RFprotect Server. Enable this option if you wish to support an Aeroscout RTLS server. Specify whether the Dell PowerConnect W controller uses an Ortonics walljack. Ortronics Wi-Jack and Wi-Jack Duo thin client access points are centrally configured and managed by the Dell PowerConnect W Networks wireless controllers to provide a high performance wireless network that integrates seamlessly into the structured cabling infrastructure. When enabled, this setting requires an Ortonics Access Point License. Enable the LED time-out function for Ortonics wall jacks when used. When enabled, this setting requires an Ortonics Access Point License. Enter the low and high temperatures in Celsius for Ortonics wall jacks. The range is from 0C to 255C degrees. When Ortonics is enabled, these settings require an Ortonics Access Point License. Enable this setting for Real-time Locating Systems (RTLS) server values and the number of consecutive missed heartbeats on a GRE tunnel before an AP reboots traps. Specify the VLAN to be associated with the remote-AP DHCP server. This field requires a remote access points license, when used. 74 | Dell PowerConnect W Configuration Reference Dell PowerConnect W AirWave 7.2 | Configuration Guide