Dell PowerEdge M520 Dell Converged Enhanced Ethernet Administrator's Guide - Page 120
Ethernet Priority Flow Control, Enabling Ethernet Pause
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
10 Congestion control Enabling Ethernet Pause To enable Ethernet Pause, perform the following steps from Privileged EXEC mode. 1. Enter global configuration mode. switch#configure terminal 2. Specify the 10-gigabit Ethernet interface. switch(config)#interface intengigabitethernet 0/2 3. Enable Ethernet Pause on the interface for both TX and RX traffic. switch(conf-if-te-0/2)#qos flowcontrol tx on rx on The following example enables an interface with 802.3x Pause flow control TX and RX. switch:admin>cmsh switch>enable switch#configure terminal Enter configuration commands, one per line. End with CNTL/Z. switch(config)#interface intengigabitethernet 0/2 switch(conf-if-te-0/2)#qos flowcontrol tx on rx on switch(conf-if-te-0/2)#exit switch(config)#end 4. Enter the copy command to save the running-config file to the startup-config file. switch#copy running-config startup-config Ethernet Priority Flow Control Ethernet Priority Flow Control (PFC) is a basic extension of the Ethernet Pause. The Pause MAC control message is extended with eight 2-byte pause numbers and a bitmask to indicate which values are valid. Each pause number is interpreted identically to the base Pause protocol; however each is applied to the corresponding Ethernet priority / class level. For example, the Pause number zero applies to priority zero, Pause number one applies to priority one, and so on. This addresses one shortcoming of the Ethernet Pause mechanism, which is disruptive to all traffic on the link. However, it still suffers from the other Ethernet Pause limitations. Ethernet Priority Flow Control includes the following features: • Everything operates exactly as in Ethernet Pause described above except there are eight high-water and low-water thresholds for each input port. This means queue levels are tracked per input port plus priority. • Pause On/Off can be specified independently for TX and RX directions per priority. • Pause time programmed into Ethernet MAC is a single value covering all priorities. • Both ends of a link must be configured identically for Ethernet Pause or Ethernet Priority Flow Control because they are incompatible. Enabling an Ethernet PFC To enable Ethernet PFC, perform the following steps from Privileged EXEC mode. 1. Enter global configuration mode. switch#configure terminal 102 Dell Converged Enhanced Ethernet Administrator's Guide 53-1002116-01