Dell PowerEdge M520 Dell Converged Enhanced Ethernet Administrator's Guide - Page 131
Configuring 802.1x on specific interface ports, default values.
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
Interface-specific administrative tasks for 802.1x 11 Configuring 802.1x on specific interface ports To configure 802.1x port authentication on a specific interface port, perform the following steps from Privileged EXEC mode. Repeat this task for each interface port you wish to modify. 1. Enter the configure terminal command to access global configuration mode. 2. Use the interface command to select the interface port to modify. switch(config)#interface extengigabitethernet 0/16 3. Use the dot1x authentication command to enable 802.1x authentication. switch(conf-if-te-0/16)#dot1x authentication 4. Enter the copy command to save the running-config file to the startup-config file. switch(conf-if-te-0/16)#exit switch(config)#end switch#copy running-config startup-config Configuring 802.1x timeouts on specific interface ports NOTE While you are free to modify the timeouts, Dell recommends that you leave timeouts set to their default values. To configure 802.1x timeout attributes on a specific interface port, perform the following steps from Privileged EXEC mode. Repeat this task for each interface port you wish to modify. 1. Enter the configure terminal command to access global configuration mode. 2. Use the interface command to select the interface port to modify. switch(config)#interface extengigabitethernet 0/16 3. Configure the timeout interval. switch(conf-if-te-0/16)#dot1x timeout supp-timeout 40 Configuring 802.1x re-authentication on specific interface ports To configure 802.1x port re-authentication on a specific interface port, perform the following steps from Privileged EXEC mode. Repeat this task for each interface port you wish to modify. 1. Enter the configure terminal command to access global configuration mode. 2. Use the interface command to select the interface port to modify. switch(config)#interface extengigabitethernet 0/16 3. Enable 802.1x authentication for the interface port. switch(conf-if-te-0/16)#dot1x enable 4. Configure reauthentication for the interface port. switch(conf-if-te-0/16)#dot1x reauthentication Dell Converged Enhanced Ethernet Administrator's Guide 113 53-1002116-01