Dell PowerEdge M520 Dell Converged Enhanced Ethernet Administrator's Guide - Page 147
Monitoring IGMP
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
Monitoring IGMP 15 IGMP snooping querier sends out IGMP queries to trigger IGMP responses from switches that wish to receive IP multicast traffic. IGMP snooping listens for these responses to map the appropriate forwarding addresses. Refer to the CEE Command Reference for complete information about the commands in this section. Use the following procedure to configure the IGMP snooping querier. 1. Enter the configure terminal command to access global configuration mode. 2. Activate the default IGMP querier functionality for the VLAN. switch(conf-if-vl-25)#ip igmp snooping querier enable vlan 25 3. Activate IGMP querier functionality for the VLAN. The valid range is 1 to 18000 seconds. The default is 125 seconds. switch(config)#ip igmp query-interval 125 4. Set the last member query interval. The valid range is 1000 to 25500 milliseconds. The default is 1000 milliseconds. switch(config)#ip igmp last-member-query-interval 1000 5. Set the Max Response Time (MRT). The valid range is 1 to 25 seconds. The default is 10 seconds. switch(config)#ip igmp query-max-response-time 10 Monitoring IGMP Monitoring the performance of your IGMP traffic allows you to diagnose any potential issues on your switch. This helps you utilize bandwidth more efficiently by setting the switch to forward IP multicast traffic only to connected hosts that request multicast traffic. Refer to the CEE Command Reference for complete information about the commands in this section. Use the following procedure to monitor IGMP snooping on a CEE/FCoE switch. 1. Enter the enable command to access Privileged EXEC mode. 2. Enter the show ip igmp groups command to display all information on IGMP multicast groups for the switch. Use this command to display the IGMP database, including configured entries for either all groups on all interfaces, or all groups on specific interfaces, or specific groups on specific interfaces. switch#show ip igmp groups 3. Use the show ip igmp statistics command to display the IGMP statistics for a VLAN or interface. switch#show ip igmp snooping statistics interface vlan 1 Dell Converged Enhanced Ethernet Administrator's Guide 129 53-1002116-01