Dell PowerEdge M520 Dell Converged Enhanced Ethernet Administrator's Guide - Page 41
Assigning FCoE map on to an interface, Configuring the CEE interfaces
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Configuring the CEE interfaces 3 Assigning FCoE map on to an interface The FCoE map cannot be edited, if it is associated to any interfaces. The FCoE map can be applied, irrespective of whether the interface is in 'switchport' or not. But the FCoE map cannot be applied on an interface, if the same interface already has a CEE map assigned to it. To assign the FCoE map to an interface, perform the following steps in global configuration mode. 1. Enter interface configuration mode. switch(config)#interface intengigabitethernet 0/0 2. Use the fcoeport command to assign the FCoE map to the interface switch(conf-if-te-0/0)#fcoeport 3. Enter the shutdown command to toggle the availability of the interface. To enable the interface: switch(conf-if-te-0/0)#no shutdown To disable the interface: switch(conf-if-te-0/0)#shutdown 4. Display the fcoe map to ensure the successful creation. switch(conf-fcoe-map)#do show fcoe-map fcoe-map default cee-map :default fcoe-vlan :6 interface(s) :te0/0 5. Repeat this procedure for any additional interfaces. Configuring the CEE interfaces Traffic from downstream CEE interfaces can be assigned to a VLAN using several methods: • The VLAN tag contained in the incoming frame • The VLAN classifiers • The Port-VLAN ID (PVID) Because the Ethernet uplink ports from the Dell FCoE hardware to the distribution layer switches will carry traffic for multiple VLANs, they are configured as 802.1q trunk ports. The downstream CEE ports connected to the server CNAs are configured as access ports with a PVID of either 10 or 20. The VLAN classifier group created for the FIP and FCoE EtherTypes must be applied to the interfaces in order to place FCoE traffic on the correct VLAN. The CEE map is also applied to the interface. If an interface is already assigned as an fcoeport, you cannot apply the CEE map to that interface. Only a single CEE map is allowed, which is created automatically with the name "default." You are not be able to delete or rename this map. Dell Converged Enhanced Ethernet Administrator's Guide 23 53-1002116-01