Dell PowerEdge R350 EMC Installation and Service Manual - Page 30

Intrusion switch, Removing the intrusion switch module

Get Dell PowerEdge R350 PDF manuals and user guides View all Dell PowerEdge R350 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Figure 16. Installing a cooling fan Next steps 1. Install the air shroud. 2. Follow the procedure listed in After working inside your system. Intrusion switch This is a service technician replaceable part only. Removing the intrusion switch module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. Remove the air shroud. Steps 1. Disconnect and remove the intrusion switch cable from the connector on the system board. NOTE: Observe the routing of the cable as you remove it from the system. 2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module. 3. Lift the intrusion switch module out of the system. 30 Installing and removing system components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
Figure 16. Installing a cooling fan
Next steps
1.
Install the air shroud
.
2.
Follow the procedure listed in
After working inside your system
.
Intrusion switch
This is a service technician replaceable part only.
Removing the intrusion switch module
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your system
.
3.
Remove the air shroud
.
Steps
1.
Disconnect and remove the intrusion switch cable from the connector on the system board.
NOTE:
Observe the routing of the cable as you remove it from the system.
2.
Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module.
3.
Lift the intrusion switch module out of the system.
30
Installing and removing system components