Dell PowerEdge R350 EMC Installation and Service Manual - Page 52

Applying thermal grease on top of the processor, Installing the heat sink

Get Dell PowerEdge R350 PDF manuals and user guides View all Dell PowerEdge R350 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 52 highlights

Figure 41. Applying thermal grease on top of the processor 3. Place the heat sink onto the processor with the cable end facing the drive carrier. 4. Align the screws on the heat sink with the standoff screws on the system board. 5. Using a Phillips #2 screwdriver, tighten the screws in the following order to secure the heat sink to the system board. a. Tighten the first screw three turns. b. Tighten the screw diagonally opposite to the screw you loosened. 6. Repeat the procedure for the remaining two screws. 7. Return to the first screw to tighten it. Figure 42. Installing the heat sink 52 Installing and removing system components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
Figure 41. Applying thermal grease on top of the processor
3.
Place the heat sink onto the processor with the cable end facing the drive carrier.
4.
Align the screws on the heat sink with the standoff screws on the system board.
5.
Using a Phillips #2 screwdriver, tighten the screws in the following order to secure the heat sink to the system board.
a.
Tighten the first screw three turns.
b.
Tighten the screw diagonally opposite to the screw you loosened.
6.
Repeat the procedure for the remaining two screws.
7.
Return to the first screw to tighten it.
Figure 42. Installing the heat sink
52
Installing and removing system components