Dell PowerEdge R740xd2 EMC Installation and Service Manual - Page 27
SATA Settings, Viewing SATA Settings, SATA Settings details, AHCI Mode or RAID Mode
View all Dell PowerEdge R740xd2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Option Description Option Description Brand Specifies the brand name. Level 2 Cache Specifies the total L2 cache. Level 3 Cache Specifies the total L3 cache. Number of Cores Specifies the number of cores per processor. Maximum Memory Specifies the maximum memory capacity per processor. Capacity Microcode Specifies the microcode. SATA Settings You can use the SATA Settings screen to view the SATA settings of SATA devices and enable SATA on your system. Viewing SATA Settings To view the SATA Settings screen, perform the following steps: Steps 1. Power on, or restart your system. 2. Press F2 immediately after you see the following message: F2 = System Setup NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart your system and try again. 3. On the System Setup Main Menu screen, click System BIOS. 4. On the System BIOS screen, click SATA Settings. SATA Settings details About this task The SATA Settings screen details are explained as follows: Option Description Embedded SATA Security Freeze Lock Write Cache Port n Enables the embedded SATA option to be set to Off, AHCI, or RAID modes. This option is set to AHCI Mode by default. Sends Security Freeze Lock command to the embedded SATA drives during POST. This option is applicable only for AHCI Mode. This option is set to Enabled by default. Enables or disables the command for the embedded SATA drives during POST. This option is set to Disabled by default. Sets the drive type of the selected device. For AHCI Mode or RAID Mode, BIOS support is always enabled. Option Description Model Drive Type Capacity Specifies the drive model of the selected device. Specifies the type of drive attached to the SATA port. Specifies the total capacity of the drive. This field is undefined for removable media devices such as optical drives. Pre-operating system management applications 27