Dell PowerEdge T620 Owner's Manual - Page 106
Installing The Control Panel—Rack Mode, Removing The Control-Panel Board, If installed
View all Dell PowerEdge T620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
3. control panel USB cable Installing The Control Panel-Rack Mode CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1. Connect the control panel cable and the control panel USB cable to the control panel module. 2. Slide the control panel into the chassis. 3. Secure the control panel to the chassis using the screw. 4. Connect the control panel cable and the control panel USB cable to the system board. 5. Close the system. 6. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals. 7. If applicable, install the front bezel. Removing The Control-Panel Board CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1. If installed, remove the front bezel. 2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals. 3. Open the system. 4. Remove the control panel. 5. Remove the screws securing the control-panel board to the control panel. 6. Lift the control-panel board away from the control panel. 106