Dell PowerEdge T620 Owner's Manual - Page 48
Removing Memory Modules, Removing and Installing a Memory Module
View all Dell PowerEdge T620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Removing Memory Modules WARNING: The memory modules are hot to the touch for some time after the system has been powered down. Allow time for the memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the components on the memory module. CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals. 2. Open the system. 3. Remove the cooling shroud. 4. Locate the appropriate memory module socket(s). CAUTION: Handle each memory module only on either card edge, making sure not to touch the middle of the memory module. 5. Press down and out on the ejectors on each end of the socket until the memory module pops out of the socket. Figure 15. Removing and Installing a Memory Module 1. memory module 2. memory-module socket ejectors (2) 3. alignment key 6. Install the cooling shroud. 7. Close the system. 8. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals. 48