Dell PowerEdge T620 Owner's Manual - Page 18
W, 750 W, or 1100 W, Power supply PSU2 - usb 3
View all Dell PowerEdge T620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Item Indicator, Button, or Icon Description Connector 4 System identification button The identification buttons on the front and back panels can be used to locate a particular system within a rack. When one of these buttons is pressed, the LCD panel on the front and the system status indicator on the back flash until one of the buttons is pressed again. Press to toggle the system ID on and off. If the system stops responding during POST, press and hold the system ID button for more than five seconds to enter the BIOS progress mode. To reset iDRAC (if not disabled in F2 iDRAC setup), press and hold for more than 15 seconds. 5 System identification connector Allows you to connect the optional system status indicator assembly through the optional cable management arm. 6 iDRAC Enterprise port Dedicated management port. NOTE: The port is available for use only if the iDRAC Enterprise license is installed on your system. 7 Power supply (PSU1) AC 495 W, 750 W, or 1100 W or DC 1100 W (when available) 8 USB connectors (6) 9 Video connector Allows you to connect USB devices to the system. The ports are USB 2.0-compliant. Allows you to connect a VGA display to the system. 10 Serial connector Allows you to connect a serial device to the system. 11 Power supply (PSU2) 12 PCIe expansion card slots full height (3) (processor 2) AC 495 W, 750 W, or 1100 W or DC 1100 W (when available) Connects up to three full-height PCI Express expansion cards. 18