Dell PowerEdge T640 EMC PowerEdge T640 Installation and Service Manual - Page 135
Optional IDSDM or vFlash module
View all Dell PowerEdge T640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
Figure 88. Installing the MicroSD card Next steps 1. Follow the procedure listed in After working inside your system on page 66. Optional IDSDM or vFlash module Removing the optional IDSDM or vFlash module Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 65. 2. Follow the procedure listed in Before working inside your system on page 66. 3. If you are replacing the IDSDM/vFlash module, remove the MicroSD cards. NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal. Steps 1. Locate the IDSDM/vFlash connector on the system board. To locate IDSDM/vFlash connector, see the System board jumpers and connectors section. 2. Holding the pull tab, lift the IDSDM/vFlash module out of the system. Installing and removing system components 135