Dell PowerEdge T640 EMC PowerEdge T640 Installation and Service Manual - Page 158
Removing the main power interposer board
![]() |
View all Dell PowerEdge T640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Figure 117. Installing the GPU power interposer board Next steps 1. Install the system board. 2. Install the PSUs. 3. Follow the procedure listed in After working inside your system on page 66. Removing the main power interposer board Prerequisites CAUTION: To prevent damage to the main power interposer board (PIB), you must remove the power supply units (PSUs) from the system before removing the PIBs. 1. Follow the safety guidelines listed in Safety instructions on page 65. 2. Follow the procedure listed in Before working inside your system on page 66. 3. Remove the PSUs. 4. Remove the system board. 5. If installed, remove the GPU PIB. Steps 1. Disconnect all the power cables from the main PIB. 2. Using the Phillips #2 screwdriver, remove the screws that secure the main PIB to the system. 3. Lift the main PIB out of the system. Figure 118. Removing the main PIB 158 Installing and removing system components
![](/manual_guide/products/dell-poweredge-t640-emc-poweredge-t640-installation-service-manual-271650b/158.png)