Epson 755c Product Information Guide - Page 10

Epson PowerLite 755c/765c Projector 6. Hold down the Num button on the remote control and use the numeric keypad to enter a 4-digit password. The password will be displayed as ****. After you enter the last digit, a confirmation screen appears. Enter the password again. 7. After you finish setting the password, press the Menu button to exit. 8. Press the Num button to deactivate the numeric keypad. Numeric keypad Num button Make a note of the password and keep it in a safe place. Turning On the Password and User's Logo To enable the password (and User's Logo, if one has been created), follow these steps: 1. Press the Freeze button on the remote control for about 5 seconds until you see the Password Protect menu. 2. Select Power ON Protect and press Enter. 3. Select ON and press Esc. After turning on this feature, you have to unplug the projector (not just turn it off) in order to activate it. The password prompt appears only after plugging in the projector and turning it on. 4. If you want to disable the password temporarily so someone can use the projector without entering the password, select Timer and press Enter. Then hold down the Num button while you use the numeric keypad to enter the number of hours (from 0 to 9999) you want the password feature disabled. If you want the projector to request the password every time it is turned on, set the timer to 0H. The timer starts counting as soon as you close the Password Protect menu. (You can check the elapsed time in this menu next to Time elapsed.) When the period defined in the Time-elapsed setting has passed, and the password is entered correctly, the elapsed time is reset to 0H and the timer starts again. Remember to disable or change this setting when you're finished using it. 5. To enable your User's Logo, select User's Logo Protect and press Enter. Then select ON and press Enter. When this feature is on, the logo image appears when the projector is turned on (if the Startup Screen is enabled in the Extended menu) and as the A/V Mute screen (if you selected Logo as the Background Color in the Extended menu). Note: None of the User's Logo features can be changed when the User's Logo Protect function is enabled. 6. Press Menu to close the Password Protect menu. Starting the Projector with a Password Note: You must unplug the projector and then plug it back in to enable password protection. When the password function is enabled, you see this screen when you plug in and turn on the projector: Hold down the Num button on the remote control as you use the numeric keypad buttons to enter the password. Once you have entered the password correctly, the password screen closes, and projection begins. If the password is not correct, you see the message Wrong password. Please try again. If you enter an incorrect password three times in succession, you see the message The projector's operation will be locked. Request code xxxxx and the projector switches to standby mode for approximately 5 minutes. Write down the request code. Then disconnect the projector's power cord from the electrical outlet, reconnect it, and turn the projector back on. When you see the Password Protect Release screen, enter the correct password. If you have forgotten the password, contact Epson for assistance and give them the request code number that appears in the Password Protect Release screen. If you enter an incorrect password 30 times in a row, the projector remains locked and you must contact an authorized Epson servicer to unlock it. 10 - Epson PowerLite 755c/765c Projector 8/05