Epson 755c Product Information Guide - Page 4

Epson PowerLite 755c/765c Projector 3. Press the P Power button on top of the projector or on the remote control. Power button Projector Remote control The projector beeps once and the Power light flashes green as the projector warms up, then an image begins to appear. When the Power light stops flashing and remains green, the projector is ready for use. Warning: Never look into the lens when the lamp is on. This can damage your eyes, and is especially dangerous for children. ❏ If you've connected a Windows®-based computer to the projector, you may see a New Hardware Wizard saying your computer has found a plug-and-play monitor; if so, click Cancel. ❏ If you don't see the image you want, press the Source Search button on the projector or the Search button on the remote control until you see the image you want to project. ❏ If you are prompted to enter a password, see "Starting the Projector with a Password" on page 10. Note: You can also use the Source buttons on the remote control to switch between devices connected to the ports identified on each button. For details, see page 5. If a projected image fails to appear, see "You Can't Project an Image" in the next column. When you're done with your presentation, shut down the projector as described on page 7. Shutting down the projector correctly prevents premature lamp failure and possible damage from overheating. You Can't Project an Image If you don't see the image you are trying to project, try the following: ❏ Make sure the cables are connected correctly. ❏ Make sure the Power light is green and not flashing and the lens cap is off. ❏ If you've connected more than one computer and/or video source, you may need to press the Source Search button on the projector's control panel or Search button on the remote control to select the correct source. (Allow a few seconds for the projector to sync up after pressing the button.) ❏ If you're using a PC notebook, see below. The Projector and Notebook Don't Display the Same Image If you're projecting from a notebook, and you can't see your image on the projection screen and on your computer at the same time, follow these guidelines. If you're using a PC notebook: ❏ On most systems, there's a function key that lets you toggle between the LCD screen and the projector, or display on both at the same time. It may be labeled CRT/LCD or have an icon such as . You may have to hold down the Fn key while pressing it. Allow a few seconds for the projector to sync up after changing the setting. ❏ If the function key doesn't permit you to display simultaneously on both screens, you should check your monitor settings to make sure both the LCD screen and the external monitor port are enabled. From the Control Panel, open the Display utility. In the Display Properties dialog box, click the Settings tab, then click Advanced. The method for adjusting the settings varies by brand; you may need to click a Monitor tab, then make sure the external Monitor port is set as your primary display and/or enabled. See your computer's documentation or online help for details. 4 - Epson PowerLite 755c/765c Projector 8/05