Epson Artisan 837 Quick Guide - Page 37

Touch Panel Safety Instructions - leaking ink

Get Epson Artisan 837 PDF manuals and user guides View all Epson Artisan 837 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

■ Allow space behind the product for the cables, and space above the product so that you can fully raise the document cover. ■ Leave enough space in front of the product for the paper to be fully ejected. ■ Leave enough room around the product for sufficient ventilation. Make sure the product is at least 4 inches (10 cm) away from the wall. ■ Do not block or cover openings in the product case or insert objects through the slots. ■ Do not use aerosol products that contain flammable gases inside or around the product. Doing so may cause fire. ■ Do not press too hard on the document table when placing the originals. ■ Do not open the scanner section while the product is faxing, copying, printing, or scanning. ■ Be careful not to trap your fingers when closing the scanner cover or scanner. ■ Do not touch the flat white cable inside the product. ■ Do not spill liquid on the product. Do not use the product near water. Do not use with wet hands. ■ Unplug the product and refer servicing to qualified service personnel under the following conditions: if the power cord or plug is damaged; if liquid has entered the product; if the product has been dropped or the case damaged; if the product does not operate normally or exhibits a distinct change in performance. ■ Adjust only those controls that are covered by the operating instructions. Except as specifically explained in your documentation, do not attempt to service the product yourself. ■ Never disassemble, modify, or attempt to repair the product by yourself, except as specifically explained in the documentation. Do not adjust controls that are not covered by the operating instructions. ■ When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside down; otherwise ink may leak from the cartridges. ■ Always keep this guide handy. Touch Panel Safety Instructions ■ Press the touch panel gently with your fingertip. Do not press with force or use your fingernail. ■ Do not use items such as ball point pens, pencils, etc. to operate the touch panel. ■ Do not place heavy items on the touch panel. Contact Epson if the panel chips or cracks; do not attempt to remove broken pieces. ■ Do not place your product in areas where abrupt changes in temperature or humidity may occur. Condensation inside the panel may cause performance to deteriorate. ■ Do not touch the panel with wet or gloved hands or through the protective sheet or sticker; it may not respond. ■ Use only a dry, soft cloth to clean the touch panel. Do not use liquid or chemical cleansers. Notices 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
Notices
37
■
Allow space behind the product for the cables, and space above the product so that you can
fully raise the document cover.
■
Leave enough space in front of the product for the paper to be fully ejected.
■
Leave enough room around the product for sufficient ventilation. Make sure the product is at
least 4 inches (10 cm) away from the wall.
■
Do not block or cover openings in the product case or insert objects through the slots.
■
Do not use aerosol products that contain flammable gases inside or around the product. Doing
so may cause fire.
■
Do not press too hard on the document table when placing the originals.
■
Do not open the scanner section while the product is faxing, copying, printing, or scanning.
■
Be careful not to trap your fingers when closing the scanner cover or scanner.
■
Do not touch the flat white cable inside the product.
■
Do not spill liquid on the product. Do not use the product near water. Do not use with wet
hands.
■
Unplug the product and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance.
■
Adjust only those controls that are covered by the operating instructions. Except as specifically
explained in your documentation, do not attempt to service the product yourself.
■
Never disassemble, modify, or attempt to repair the product by yourself, except as specifically
explained in the documentation. Do not adjust controls that are not covered by the operating
instructions.
■
When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside
down; otherwise ink may leak from the cartridges.
■
Always keep this guide handy.
Touch Panel Safety Instructions
■
Press the touch panel gently with your fingertip. Do not press with force or use your fingernail.
■
Do not use items such as ball point pens, pencils, etc. to operate the touch panel.
■
Do not place heavy items on the touch panel. Contact Epson if the panel chips or cracks; do
not attempt to remove broken pieces.
■
Do not place your product in areas where abrupt changes in temperature or humidity may
occur. Condensation inside the panel may cause performance to deteriorate.
■
Do not touch the panel with wet or gloved hands or through the protective sheet or sticker; it
may not respond.
■
Use only a dry, soft cloth to clean the touch panel. Do not use liquid or chemical cleansers.