Epson DFX-8000 User Manual - Page 238
Tear Off, Frontrear, Swi&ch
View all Epson DFX-8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 238 highlights
Options Problem A pull tractor is installed and the printer does not feed continuous paper properly (continued). Solution Your application program may cancel the skip over perforation set by DIP switch 3-3. Check that your application program's settings are correct. Skip over perforation is set, but the perforation does not fall in the center of the skip. The page length may be set incorrectly. Set DIP swi&ch 3-2 to match your paper length. You can also set the page length using ESC C or ESC C 0. See pages 3-17, 9-13, and 9-14. The top of form position may be too high or too low. Adjust the top of form position so that the perforation is centered within the skip area. See page 3-33. The paper cutter is installed and the printer does not feed continuous paper properly. When you press the TEAR OFF or FRONTREAR button, the paper cutter does not cut the paper. The paper cutter's connector may not be plugged securely into the printer. Turn off the printer. Open the rear flap and check the paper cutter connector. See page 5-22. 7-20 Troubleshooting