Epson EPL-N2000 User Manual - Page 113
Using Hex Dump Mode, Write Error Card, Continue, Writing Card, Form Feed, Hex Dump, Reset All
View all Epson EPL-N2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Write Error Card Write Error SIMM The printer is not able to write to the PCMCIA card. Do one of the following: (1) turn off the printer, remove the card, then turn the printer on again; (2) remove the card while the printer is on, then press Continue to clear the message; (3) reset the printer by pressing ALT and Continue at the same time. Writing Card The printer is writing data to the PCMCIA card; wait a moment for it to finish. Using Hex Dump Mode Hex dump mode is a special feature that makes it easy for experienced users to find the cause of communication problems between the printer and the computer. In hex dump mode, the printer produces an exact printout of the codes it receives. Follow these steps to turn on hex dump mode and send a print job using it: 1. Make sure paper is loaded and the printer is turned off. 2. Hold down the Form Feed button while you turn on the printer; hold down the button until you see Hex Dump on the control panel display. 3. Open an application and print a document. Your printer prints out all the codes it receives in hexadecimal format. 4. To turn off hex dump mode, turn off the printer or reset it by pressing and holding down the ALT and Continue buttons at the same time. When Reset All appears on the display, release the buttons. Troubleshooting 6-9