Epson PhotoPC 750Z User Setup Information - Page 44

Connecting to a Macintosh, and your Macintosh.

Get Epson PhotoPC 750Z PDF manuals and user guides View all Epson PhotoPC 750Z manuals
Add to My Manuals
Save this manual to your list of manuals

Page 44 highlights

4 Depending on the type of cable you have, line up either the arrow or the flat side of the cable connector with the mark on the camera's serial port. Then insert the connector. Connecting to a Macintosh Make sure you have the Macintosh/Direct Print cable that came with your camera. Before you start, turn off the camera and your Macintosh. 1 Locate the modem port or printer port on the back of your Macintosh. You can use either port to connect the camera. 5 Turn on the camera and your computer system. NOTE If you have problems connecting to the COM port you have selected, check your computer's COM port configuration and try again. See page 5-11 for more tips on connecting your camera and getting the computer to see it. NOTE If you are sharing a serial port that you use for another device, make sure AppleTalk® is turned off. Your Macintosh may not recognize the camera if AppleTalk is on. Also, if you have problems connecting to the printer port, use the modem port instead. See page 5-11 for more tips on connecting your camera and getting the computer to see it. 5-6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
5-6
4
Depending on the type of cable you have, line up either
the arrow or the flat side of the cable connector with
the mark on the camera’s serial port. Then insert the
connector.
5
Turn on the camera and your computer system.
NOTE
If you have problems connecting to the COM port you have
selected, check your computer’s COM port configuration and
try again. See page 5-11 for more tips on connecting your camera
and getting the computer to see it.
Connecting to a Macintosh
Make sure you have the Macintosh/Direct Print cable that
came with your camera. Before you start, turn off the camera
and your Macintosh.
1
Locate the modem port
or printer port
on
the back of your Macintosh. You can use either port to
connect the camera.
NOTE
If you are sharing a serial port that you use for another
device, make sure AppleTalk
is turned off. Your Macintosh
may not recognize the camera if AppleTalk is on. Also, if you
have problems connecting to the printer port, use the
modem port instead. See page 5-11 for more tips on
connecting your camera and getting the computer to see it.