Epson Stylus C60 Printer Basics - Page 43

Problems and Solutions Setup and Software Installation Problems The printer makes noise after ink cartridge installation. I The first time you install ink cartridges, the printer must charge its print head for a few minutes. Wait until charging finishes (the green P power light stops flashing) before you turn off the printer, or it may charge improperly and use excess ink the next time you turn it on. If the printer stops moving or making noise, but the green P power light is still flashing after 5 minutes, turn off the printer. If the light is still flashing when you turn it back on, contact EPSON as described on page 47. I Make sure the ink cartridge clamps are locked down completely and no packing material remains in the printer. Turn off the printer, wait a moment, then turn it back on to clear the error. You're having problems installing the printer software. I Make sure your printer is turned on and the printer cable is securely connected at both ends. Then carefully follow the installation instructions on the Start Here sheet. Also make sure your system meets the requirements on pages 49 and 50. I Close your other programs, including any screen savers and virus protection software, and install again. I If your printer icon (C60 Series) doesn't appear in the Macintosh Chooser, you may have too many items in the Chooser. Delete any unused items and check the Chooser again. I For Windows 2000, if you see an error message or your software doesn't install correctly, you may not have software installation privileges. Contact your System Administrator. Solving Problems 39