Fujitsu MAN3367FC Manual/User Guide - Page 67
Installation
![]() |
View all Fujitsu MAN3367FC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
CHAPTER 5 Installation 5.1 Notes on Handling Drives 5.2 Setting 5.3 Mounting Drives 5.4 Dismounting Drives 5.5 Checking Operation after Installation and Preparing the IDD for Use 5.6 Spare Disk Drive This chapter describes the notes on handling drives, setting, mounting drives, confirming drive operations after installation and preparation for use, and dismounting drives. 5.1 Notes on Handling Drives The items listed in the specifications in Table 2.1 must be strictly observed. (1) General notes a) Do not give the drive shocks or vibrations exceeding the value defined in the standard because it may cause critical damage to the drive. Especially be careful when unpacking. b) Do not leave the drive in a dirty or contaminated environment. c) Since static discharge may destroy the CMOS semiconductors in the drive, note the following after unpacking: • Use an antistatic mat and body grounding when handling the drive. • Hold the DE when handling the drive. Do not touch PCAs except for setting. CAUTION Hot temperature To prevent injury, do not handle the drive until after the device has cooled sufficiently after turning off the power. The DE and LSI become hot during operation and remain hot immediately after turning off the power. C141-E133-02EN 5-1
![](/manual_guide/products/fujitsu-man3367fc-manualuser-guide-b6b0455/67.png)