HP Color LaserJet CP2020 Service Manual - Page 182
Fuser, Warning, Caution,
View all HP Color LaserJet CP2020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
Fuser WARNING! The fuser might be hot. After turning off the product power, allow the fuser to cool for at least five minutes before removing it. NOTE: The fuser can be removed without removing the upper-cover assembly. However, it might be easier to access some of the connectors with this component removed. 1. Remove the following components: ● Right cover. See Right cover on page 108. ● Upper-cover assembly. See Upper-cover assembly on page 121. ● Left cover. See Left cover on page 126. ● Rear door (simplex products). See Rear door (simplex product) on page 104. ● Rear cover (simplex products). See Rear cover and feed guide (simplex product) on page 112. ● Rear-upper cover (duplex products). See Rear-upper cover (duplex product) on page 111. ● Rear door (duplex products). See Rear door (duplex product) on page 106. ● Rear-lower cover (duplex products). See Rear-lower cover and rear-door links (duplex product) on page 116. 2. Duplex models only: Remove three screws (callout 1) and separate the duplex reverse-drive assembly from the product. CAUTION: The duplex reverse-drive assembly is still attached to the product. Carefully set the assembly out of the way. Figure 6-129 Remove the fuser (1 of 8) 1 162 Chapter 6 Removal and replacement ENWW