HP DL320 HP ProLiant DL320 Generation 2 Server Maintenance and Service Guide - Page 51
System Board, Remove the SCSI module if installed. See Single Channel Wide Ultra3 SCSI
UPC - 829160513218
View all HP DL320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Removal and Replacement Procedures System Board To remove the system board: 1. Power down the server. See "Powering Down the Server" in this chapter. 2. Remove the access panel. See "Access Panel" in this chapter. 3. Remove the PCI riser board assembly. See "PCI Riser Board Assembly" in this chapter. 4. Disconnect the fan cables 1 through 4. See "Fans" in this chapter. 5. Remove the center wall. See "Center Wall" in this chapter. 6. Remove the SCSI module (if installed). See "Single Channel Wide Ultra3 SCSI Controller Module," in this chapter. 7. Remove any DIMMs. See "Memory Modules" in this chapter. 8. Disconnect the power supply from the system board. See "Power Supply" in this chapter. 9. Disconnect the optical device/diskette drive assembly cable from the system board. See "Optical Device/Diskette Drive Assembly Cable" in this chapter. 10. Disconnect the SCSI or ATA drive cables from the hard drives. See "Hard Drives" in this chapter. 11. Remove the system battery. See "Battery" in this chapter. 2-40 HP ProLiant DL320 Generation 2 Server Maintenance and Service Guide HP CONFIDENTIAL Codename: Moonstar 306 Part Number: 293164-004 Last Saved On: 9/22/03 1:47 PM