HP EliteDesk 800 G3 Maintenance and Service Guide - Page 61
Installing a 2.5-inch hard drive, front of the drive into the drive bay
![]() |
View all HP EliteDesk 800 G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Installing a 2.5-inch hard drive 1. Prepare the computer for disassembly (Preparation for disassembly on page 19) 2. Remove the access panel (Access panel on page 20) 3. Install four black-and-blue M3 mounting screws (two on each side of the drive). NOTE: M3 metric mounting screws can be purchased from HP. When replacing a drive, transfer the four mounting screws from the old drive to the new drive. 4. Align the front mounting screws on the drive with the J-slots on the sides of the drive bay. Press the front of the drive into the drive bay, and then slide the drive forward (1). Then press the rear of the drive into the drive bay (2) so that the drive is secured in place. Drives 51
![](/manual_guide/products/hewlettpackard-elitedesk-800-g3-maintenance-service-guide-31be2e7/61.png)
Installing a 2.5-inch hard drive
1.
Prepare the computer for disassembly (
Preparation for disassembly
on page
19
)
2.
Remove the access panel (
Access panel
on page
20
)
3.
Install four black-and-blue M3 mounting screws (two on each side of the drive).
NOTE:
M3 metric mounting screws can be purchased from HP.
When replacing a drive, transfer the four mounting screws from the old drive to the new drive.
4.
Align the front mounting screws on the drive with the J-slots on the sides of the drive bay. Press the
front of the drive into the drive bay, and then slide the drive forward
(1)
. Then press the rear of the drive
into the drive bay
(2)
so that the drive is secured in place.
Drives
51