HP EliteDesk 800 G3 Maintenance and Service Guide - Page 74
Power supply
![]() |
View all HP EliteDesk 800 G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Power supply For a list of available power supplies, see Computer major components on page 5. The power supply is secured to the rear of the chassis with three screws. Three cables connect the power supply to the system board. 1. Prepare the computer for disassembly (Preparation for disassembly on page 19). 2. Remove the access panel (Access panel on page 20). 3. Remove the drive cage (Drive cage on page 28). 4. Remove the three Torx T15 screws that connect the power supply to the rear of the chassis. 5. From the inside of the chassis, remove the power supply cables from the clips built into the bottom of the chassis. 6. Disconnect the power supply cables from the following system board connector: ● PWRCMD 64 Chapter 4 Removal and replacement procedures - Microtower (MT) chassis
![](/manual_guide/products/hewlettpackard-elitedesk-800-g3-maintenance-service-guide-31be2e7/74.png)