HP LH4r HP Netserver LP 2000r User Guide - Page 127
Processors, Chipset, Memory, Video, PCI Bus, CD-ROM
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Appendix A Specifications Table A-4. HP Netserver Hardware Specifications Processors Chipset Intel Pentium III (up to 2 processors) processors, at supported speeds of 866, 933 MHz; and 1 GHz, with 256 KB level 2 cache on processor. Serverworks LE chip set with 133 MHz bus speed support. Memory Video SCSI IDE Supports up to four SDRAM DIMMS (168 pin) for a maximum of 4 GB. Supported DIMM types: 128 MB, 256 MB, 512 MB and 1 GB, PC 133 running at 133 MHz, 72 bits wide, ECC single-bit correcting, multi-bit detecting. Embedded ATI Rage XL chip video with 4 MB SGRAM/SDRAM. Supports up to 1600x1200, @ 65K colors, with onboard standard video connector. Refer to Table A-5, "Video Display Modes" for more details. Embedded Symbios Ultra-3 SCSI dual channel controller; Ultra 160 MB/s transfer rate with two 68-pin connectors. Embedded Enhanced-IDE dual channel controller. LAN PCI Bus I/O CD-ROM Two Embedded Intel 82559 10/100 PCI Fast Ethernet Controllers with onboard standard LAN connectors ( LAN Power On/Off and Wake on LAN is enabled or disabled on LAN A via BIOS setup). Three 32/64-bit, 33 MHz speed, 5 volt PCI slots on riser board within PCI card cage. Two Serial ports (including one Management/Serial) and one bi-directional parallel port with ECP/EPP high-speed support; one PS/2 mouse, one PS/2 keyboard, and two USB connectors. One standard CD-ROM drive; IDE interface; 48x speed. 121