HP LH4r HP Netserver LP 2000r User Guide - Page 8
Refer to Applying Power to the HP Netserver
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Chapter 1 Controls, Ports and Indicators Table 1-1. Control Panel Switches and Indicators Control/Indicator Description Power On/Off/Sleep Switch & LED Power Power LED Switch The power switch turns the Netserver power On or Off. If sleep states are available, it also transitions between Power On and sleep states. Sleep states are NOS dependent and only available if your NOS supports power management based on the ACPI (Advanced Configuration and Power Interface) standard. Refer to "Applying Power to the HP Netserver" and "Sleep States (ACPI)" later in this chapter. Reset Switch The LED indicates the power state of the Netserver: • Steady Green indicates the Netserver is operating normally. • Blinking Green indicates the Netserver is in a sleep state and under ACPI control. • Off (unlit) indicates the Netserver is powered off or in standby mode. This switch creates a hard system reset, which is equivalent to a power-on reset. RESET 2