HP LH4r HP Netserver LP 2000r User Guide - Page 21
Installing Mass Storage Devices
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
3 Installing Mass Storage Devices Introduction The HP Netserver LP 2000r comes standard with an IDE CD-ROM and a slim-line flexible disk drive, and can accommodate up to six Hot Swap SCSI hard drives. A SCSI tape backup drive may be connected as an option to the external SCSI connector at the rear. Tools Required No tools are required to install a SCSI drive in the Netserver. If the SCSI drive is not pre-mounted in its tray, you will need the following tools for this task: • Phillips size 1 screwdriver • Check the documentation that came with the drive for additional tool requirements Mass Storage Guidelines • General Guidelines ◊ Use care when unpacking and handling the SCSI disk drives. The hard disk drives are very susceptible to mechanical shock and can be easily damaged by a drop as short as one-quarter of an inch. ◊ Do not stack drives. ◊ The Netserver may have up to 6 Hot Swap SCSI hard disk drives (HDD). A flexible disk drive and CD-ROM drive are standard on all models of the HP Netserver LP 2000r. See Figure 3-1. ◊ If a backup tape drive is used, it must be connected externally using the external 68-pin SCSI connector at the rear of the Netserver. • IDE Devices ◊ The embedded IDE controller is an Enhanced-IDE dual channel controller and provides two connectors (IDE-1 and IDE-2) for IDE devices. Refer to "System Board Layout" in Appendix A, "Specifications." ◊ The IDE CD-ROM has only one connector on the cable from the primary channel (IDE-1) connector. 15