HP LH4r HP Netserver Service Handbook, Volume 2 - Mid - Page 25
DIMM Slot LED Blink Codes
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
DIMM Slot LED Blink Codes System Board LED 0 LED 1 LED 2 LED 3 Processor Error Codes Processor errors are indicated by blinking patterns of the DIMM slot LEDs that alternate at 1 Hz, as listed below: ²= LED off O = LED on LED LED LED LED 01 2 3 ²O O O O ²²² O ²O O ²O ²² Processor Error Status Indications Error Condition Voltage Regulator Module for Primary CPU Bad Voltage Regulator Module for Secondary CPU Bad Action Check that primary voltage regulator module (VRM) is correctly seated. If problem persists, replace VRM. Check that secondary voltage regulator module (VRM) is correctly seated. If problem persists, replace VRM. ²O O ² O ²²O O O ²² ²²O O CPU Over Temperature CPU or Terminator Board Not Installed Check fan for function. Turn off system, wait 20-25 minutes for system to cool, and restart system. Install CPU in primary CPU slot and CPU or terminator board in secondary CPU slot. DIMM Status Error Codes When no processor error condition exists, the DIMM slot LEDs display the status of the DIMMs in the corresponding slots, as follows: • OFF: no DIMM installed • Flashes ON and OFF at 1 Hz in 50/50 proportion of time: uncorrectable error or inappropriate DIMM • Flashes ON and OFF at 1 Hz in 90/10 proportion of time: non-HP DIMM installed • ON: HP DIMM installed 17