HP LH4r HP Netserver Service Handbook, Volume 2 - Mid - Page 95
Duplex, non-disk array model with internal controller standard model, Default Switch Settings
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Duplex, non-disk array model with internal controller (standard model) External terminator T built into cable IDE C1 Flexible Disk Drive CD-ROM SCSI or IDE Device System Board Internal terminator I2C built into board SCSI B SCSI A C5 C5 T Hot Swap Subsystem Off On UPPER CAGE 1 SCSI ID 2 3 ID ID ID 4 1 0 3 5 6 UPPER CAGE LOWER CAGE 1 2 3 4 5 6 ID ID ID 4 5 6 LOWER CAGE Default Switch Settings These are the default SCSI address settings for this model. SCSI ID 2 is reserved for an added DAT (Digital Audio Tape) drive that can be installed in the upper horizontal Shelf 3. The CD-ROM drive is set for SCSI ID 5. 87
87
Duplex, non-disk array model with internal controller (standard model)
Hot Swap
Subsystem
SCSI or IDE
Device
CD-ROM
System Board
IDE
SCSI A
SCSI B
T
Flexible Disk
Drive
T
Internal
terminator
built into board
External terminator
built into cable
IC
2
C1
C5
C5
UPPER
CAGE
1
2
3
4
5
6
LOWER
CAGE
1
2
3
4
5
6
6
5
4
1
0
3
SCSI ID
UPPER CAGE
LOWER CAGE
ID
ID
ID
ID
ID
ID
Off
On
Default Switch Settings
These are the default SCSI address settings for this model. SCSI
ID 2 is reserved for an added DAT (Digital Audio Tape) drive that
can be installed in the upper horizontal Shelf 3. The CD-ROM
drive is set for SCSI ID 5.